K_MAC WITH - SOME OF THE BEST SUSPENSION TALENT in the industry, has been thoroughly researching, designing, race testing and manufacturing "BOLT ON" CAMBER, CASTER & TOE adjustment kits for mass produced automobiles since the early 1970's.
|
THE KITS REDUCE UNEVEN, PREMATURE tyre WEAR, improve traction and high speed directional directional stability, plus allow ongoing adjustment for accident damage, kerb knocks or race / rally settings. By the 1980's, the majority of new car manufacturers had deleted adjustment facilities, other than front toe (but adjusting "toe" however ONLY ALTERS THE WEAR POSITION, and actually increases the overall wear rate. This deletion was brought about by cost cutting and the ever increasing speed of vehicle assembly lines with insufficient time for adjustment.
K-MAC THEREFORE SAW THE NEED and set about to design and manufacture a complete "Bolt On" range of front,Camber and Caster & rear Camber and Toe kits to satisfy the demand from sports / competition enthusiats or simply frustrated consumers with expensive / premature tire wear problems, which were brought about by uneven wear, altered suspension height, carrying extra load, kerb knocks, driving on high cambered roads or front / rear wheel squat, with subsequent inner edge tire wear. Above problems were further exacerbated by the advent in the 1980's of "off the shelf" wide, expensive low profile tires, where facilities for adjusting Camber because of the extra width are an essential requirement to maintain even tire wear / traction.
|